PIC16F1938_13 Datasheet, PDF (385/488 Pages) Microchip Technology – 28/40/44-Pin Flash-Based, 8-Bit CMOS Microcontrollers with LCD Driver

PIC16(L)F1938/9
30.3 DC Characteristics: PIC16(L)F1938/39-I/E (Power-Down)
PIC16LF1938/39
PIC16F1938/39
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Param
No.
D023
D023
D024
D024
Device Characteristics Min.
Power-down Base Current (IPD)⁽²⁾
Base IPD
—
—
Base IPD
—
—
—
—
—
—
—
Typ†
0.06
0.08
15
18
19
0.5
0.8
16
19
Max.
+85°C
Max.
+125°C
Units
1.0
8.0
A
2.0
9.0
A
35
45
A
40
50
A
45
55
A
6.0
9.0
A
7.0
10
A
35
45
A
40
50
A
Conditions
VDD
Note
1.8 WDT, BOR, FVR, and T1OSC
3.0 ^{disabled, all Peripherals Inactive}
1.8 WDT, BOR, FVR, and T1OSC
3.0 ^{disabled, all Peripherals Inactive}
5.0
1.8 LPWDT Current (Note 1)
3.0
1.8 LPWDT Current (Note 1)
3.0
D025
—
20
45
—
8.5
23
—
8.5
26
55
A
5.0
30
A
1.8 FVR current
33
A
3.0
D025
D026
D026
—
32
55
70
A
1.8 FVR current (Note 4)
—
39
72
80
A
3.0
—
70
100
110
A
5.0
—
7.5
25
28
A
3.0 BOR Current (Note 1)
—
34
57
67
A
3.0 BOR Current (Note 1, Note 4)
D027
D027
*
†
Note 1:
2:
3:
4:
—
67
120
130
A
5.0
—
0.6
5.0
9.0
A
1.8 T1OSC Current (Note 1)
—
1.8
6.0
12
A
3.0
—
16
45
50
A
1.8 T1OSC Current (Note 1)
—
21
50
55
A
3.0
—
25
55
65
A
5.0
These parameters are characterized but not tested.
Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral  current can be determined by subtracting the base IDD or IPD current from this limit. Max
values should be used when calculating total current consumption.
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
A/D oscillator source is FRC.
0.1 F capacitor on VCAP (RA0).
 2011-2013 Microchip Technology Inc.
DS40001574C-page 385