PIC16F610 Datasheet, PDF (149/180 Pages) Microchip Technology – 14-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F610/616/16HV610/616
15.5 DC Characteristics: PIC16F610/616/16HV610/616-I (Industrial)
PIC16F610/616/16HV610/616-E (Extended) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Sym
Characteristic
Min
Typ† Max Units
Conditions
Capacitive Loading Specs on
Output Pins
D101* COSC2 OSC2 pin
—
—
15
pF In XT, HS and LP modes when
external clock is used to drive
OSC1
D101A* CIO
All I/O pins
—
—
50
pF
Program Flash Memory
D130 EP
Cell Endurance
10K
100K
—
E/W -40°C ≤ TA ≤ +85°C
D130A ED
Cell Endurance
1K
10K
—
E/W +85°C ≤ TA ≤ +125°C
D131 VPR
VDD for Read
VMIN
—
5.5
V VMIN = Minimum operating
voltage
D132 VPEW VDD for Erase/Write
4.5
—
5.5
V
D133 TPEW Erase/Write cycle time
—
2
2.5
ms
D134 TRETD Characteristic Retention
40
—
—
Year Provided no other specifications
are violated
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended to use an external
clock in RC mode.
2: Negative current is defined as current sourced by the pin.
3: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels represent
normal operating conditions. Higher leakage current may be measured at different input voltages.
4: Including OSC2 in CLKOUT mode.
© 2007 Microchip Technology Inc.
Preliminary
DS41288C-page 147