English
Language : 

PIC16F610 Datasheet, PDF (147/180 Pages) Microchip Technology – 14-Pin, Flash-Based 8-Bit CMOS Microcontrollers
PIC16F610/616/16HV610/616
15.4 DC Characteristics: PIC16F610/616/16HV610/616-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +125°C for extended
Param
No.
Device Characteristics
Min
Typ†
Max Units
VDD
Conditions
Note
D020E Power-down Base
Current (IPD)(2)
— 0.05
9
μA
2.0 WDT, BOR, Comparators, VREF and
T1OSC disabled
— 0.15 11
μA
3.0
PIC16F610/616
— 0.35 15
μA
5.0
— 350 —
μA
2.0
PIC16HV610/616
— 350 —
μA
3.0
D021E
4
— 200 nA
5.0 Note 3
—
1
TBD μA
2.0 WDT Current(1)
—
2 TBD μA
3.0
D022E
—
8 TBD μA
5.0
—
3
TBD μA
3.0 BOR Current(1)
D023E
—
4 TBD μA
5.0
—
32 TBD μA
2.0 Comparator Current(1), both
—
60 TBD μA
3.0 comparators enabled
D024E
— 120 TBD μA
—
30
70
μA
5.0
2.0 CVREF Current(1) (high range)
—
45
90
μA
3.0
D025E*
—
75 120 μA
5.0
—
39
91
μA
2.0 CVREF Current(1) (low range)
—
59 117 μA
3.0
D026E
—
98
156
μA
— 4.5
25
μA
5.0
2.0 T1OSC Current(1), 32.768 kHz
—
5
30
μA
3.0
D027E
—
6
40
μA
5.0
— 0.30 12
μA
3.0 A/D Current(1), no conversion in
— 0.36 16
μA
5.0 progress
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral Δ current can be determined by subtracting the base IDD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
3: Shunt regulator is always enabled and always draws operating current.
© 2007 Microchip Technology Inc.
Preliminary
DS41288C-page 145