TLE7263E Datasheet, PDF (44/63 Pages) Infineon Technologies AG – Integrated HS-CAN, LIN, LDO and HS Switch System Basis Chip

TLE 7263E
Electrical Characteristics
Table 13 Electrical Characteristics (cont’d)
V_S = 13.5 V; I_CC1 = 1 mA; 4.9 V < V_CC1/2 < 5.1 V; SBC Active Mode; all outputs open;
-40 °C < T_j < 150 °C (max. 125 °C for CAN circuit characteristics); all voltages with
respect to ground; positive current defined flowing into pin; unless otherwise specified.
Parameter
Symbol Limit Values Unit Test Condition
Min. Typ. Max.
Dynamic Transceiver Characteristics
Slew rate falling edge S_fslope -3
–
-1
V/µs 60% > V_bus > 40%
1 µs < (τ = R_l × C_bus)
< 5 µs;
V_S = 13.5 V;
Active mode
(LIN Spec 1.3;
Line 10.3.1)
Slew rate rising edge S_rslope 1
–
3
V/µs 40% < V_bus < 60%
1 µs < (τ = R_l × C_bus)
< 5 µs;
V_S = 13.5 V;
Active mode.
(LIN Spec 1.3;
Line 10.3.1)
Slope symmetry
t_slopesym -5
–
5
µs t_fslope - t_rslope;
V_S = 13.5 V
(LIN Spec 1.3;
Line 10.3.3)
Propagation delay
TxD LOW to bus
t_d(L),T
–
1
4
µs (LIN Spec 1.3;
Line 10.3.6)
Propagation delay
TxD HIGH to bus
t_d(H),T
–
1
4
µs (LIN Spec 1.3;
Line 10.3.6)
Propagation delay
t_d(L),R
–
1
bus dominant to RxD
LOW
6
µs C_RxD = 20 pF;
(LIN Spec 1.3;
Line 10.3.7)
Propagation delay
t_d(H),R
–
1
bus recessive to RxD
HIGH
6
µs C_RxD = 20 pF;
(LIN Spec 1.3;
Line 10.3.7)
Receiver delay
symmetry
t_sym,R
-2
–
2
µs t_sym,R = t_d(L),R - t_d(H),R
(LIN Spec 1.3;
Line 10.3.8)
Data Sheet
44
Rev. 1.51, 2007-06-22