|
HMT112U7BFR8C-G7 Datasheet, PDF (24/51 Pages) Hynix Semiconductor – 240pin DDR3 SDRAM Registered DIMM | |||
|
◁ |
Slew Rate Definitions for Single-Ended Input Signals
See 7.5 âAddress / Command Setup, Hold and Deratingâ on page 138 in âDDR3L Device Operationâ for sin-
gle-ended slew rate definitions for address and command signals.
See 7.6 âData Setup, Hold and Slew Rate Deratingâ on page 145 in âDDR3L Device Operationâ for single-
ended slew rate definition for data signals.
Slew Rate Definitions for Differential Input Signals
Input slew rate for differential signals (CK, CK and DQS, DQS) are defined and measured as shown in table
and Figure below.
Differential Input Slew Rate Definition
Description
Measured
Min
Max
Defined by
Differential input slew rate for rising edge
(CK-CK and DQS-DQS)
VILdiffmax VIHdiffmin [VIHdiffmin-VILdiffmax] / DeltaTRdiff
Differential input slew rate for falling edge
(CK-CK and DQS-DQS)
VIHdiffmin VILdiffmax [VIHdiffmin-VILdiffmax] / DeltaTFdiff
Notes:
The differential signal (i.e. CK-CK and DQS-DQS) must be linear between these thresholds.
Delta
TRdiff
vIHdiffmin
0
Delta
TFdiff
vILdiffmax
Differential Input Slew Rate Definition for DQS, DQS# and CK, CK#
Differential Input Slew Rate Definition for DQS, DQS and CK, CK
Rev. 0.1 / Nov. 2009
24
|
▷ |