K30P121M100SF2V2 Datasheet, PDF (59/67 Pages) Freescale Semiconductor, Inc – K30 Sub-Family

Peripheral operating requirements and behaviors
Table 47. TSI electrical specifications (continued)
Symbol
I_{TSI_RUN}
I_{TSI_LP}
Description
Current added in run mode
Low power mode current adder
Min.
—
—
Typ.
55
1.3
Max.
—
2.5
Unit
Notes
μA
μA
13
1. The TSI module is functional with capacitance values outside this range. However, optimal performance is not guaranteed.
2. Fixed external capacitance of 20 pF.
3. REFCHRG = 2, EXTCHRG=0.
4. REFCHRG = 0, EXTCHRG = 10.
5. V_DD = 3.0 V.
6. The programmable current source value is generated by multiplying the SCANC[REFCHRG] value and the base current.
7. The programmable current source value is generated by multiplying the SCANC[EXTCHRG] value and the base current.
8. Measured with a 5 pF electrode, reference oscillator frequency of 10 MHz, PS = 128, NSCN = 8; Iext = 16.
9. Measured with a 20 pF electrode, reference oscillator frequency of 10 MHz, PS = 128, NSCN = 2; Iext = 16.
10. Measured with a 20 pF electrode, reference oscillator frequency of 10 MHz, PS = 16, NSCN = 3; Iext = 16.
11. Sensitivity defines the minimum capacitance change when a single count from the TSI module changes. Sensitivity
depends on the configuration used. The documented values are provided as examples calculated for a specific
configuration of operating conditions using the following equation: (C_ref * I_ext)/( I_ref * PS * NSCN)
The typical value is calculated with the following configuration:
I_ext = 6 μA (EXTCHRG = 2), PS = 128, NSCN = 2, I_ref = 16 μA (REFCHRG = 7), C_ref = 1.0 pF
The minimum value is calculated with the following configuration:
I_ext = 2 μA (EXTCHRG = 0), PS = 128, NSCN = 32, I_ref = 32 μA (REFCHRG = 15), C_ref = 0.5 pF
The highest possible sensitivity is the minimum value because it represents the smallest possible capacitance that can be
measured by a single count.
12. Time to do one complete measurement of the electrode. Sensitivity resolution of 0.0133 pF, PS = 0, NSCN = 0, 1
electrode, EXTCHRG = 7.
13. REFCHRG=0, EXTCHRG=4, PS=7, NSCN=0F, LPSCNITV=F, LPO is selected (1 kHz), and fixed external capacitance of
20 pF. Data is captured with an average of 7 periods window.
6.9.2 LCD electrical characteristics
Table 48. LCD electricals
Symbol Description
Min.
Typ.
f_Frame LCD frame frequency
28
C_LCD LCD charge pump capacitance — nominal value
—
C_BYLCD LCD bypass capacitance — nominal value
—
C_Glass LCD glass capacitance
—
30
100
100
2000
Table continues on the next page...
Max.
58
—
—
8000
Unit
Notes
Hz
nF
1
nF
1
pF
2
K30 Sub-Family Data Sheet, Rev. 1, 6/2012.
Freescale Semiconductor, Inc.
Preliminary
59
General Business Information