MC9S08AW60 Datasheet, PDF (287/320 Pages) Freescale Semiconductor, Inc – Microcontrollers

Appendix A Electrical Characteristics and Timing Specifications
A.7 Supply Current Characteristics
Table A-8. Supply Current Characteristics
Num C
Parameter
Symbol
V_DD
(V)
Typ¹
Max
Unit
Temp
(°C)
2
1
P ^{Run supply current measured at}
(CPU clock = 2 MHz, f_Bus = 1 MHz)
RI_DD
5 0.750 0.950
3 0.570 0.770 ^{mA –40 to 125°C}
2
P ^{Run supply current2 measured at}
(CPU clock = 16 MHz, f_Bus = 8 MHz)
RI_DD
5
4.9
5.10
3
3.5
3.70
mA –40 to 125°C
Stop2 mode supply current
3P
S2I
DD
7.5
5 0.900 60⁴
7.0
3 0.720 50
–40 to 85°C
µA –40 to 125°C
–40 to 85°C
µA –40 to 125°C
Stop3 mode supply current
4P
S3I
DD
8.0
5 0.975 90⁴
7.1
3 0.825 85
–40 to 85°C
µA –40 to 125°C
–40 to 85°C
µA –40 to 125°C
5
C _{RTI adder to stop2 or stop3}³
5
300
500
500
nA
–40 to 85°C
–40 to 125°C
S23I
DDRTI
3
300
500
500
nA
–40 to 85°C
–40 to 125°C
5
110
180
µA –40 to 125°C
6
C LVD adder to stop3 (LVDE = LVDSE = 1) _S3IDDLVD
3
90
160
µA –40 to 125°C
7
C ^{Adder to stop3 for oscillator enabled4}
(OSCSTEN =1)
S3I_DDOSC
5,3
5
8
µA –40 to 125°C
1 _{Typical values are based on characterization data at 25°C unless otherwise stated. See Figure A-5 through Figure A-7 for}
typical curves across voltage/temperature.
2 _{All modules except ADC active, ICG configured for FBE, and does not include any dc loads on port pins}
3 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait}
mode. Wait mode typical is 220 µA at 5 V with f_Bus = 1 MHz.
4 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal, low power mode}
(HGO = 0), clock monitor disabled (LOCD = 1).
MC9S08AW60 Data Sheet, Rev.1.0
Freescale Semiconductor
287