XRT75R03D_06 Datasheet, PDF (95/135 Pages) Exar Corporation – EXAR DATA SHEET FORMAT TEMPLATES

REV. 1.0.4
XRT75R03D
THREE CHANNEL E3/DS3/STS-1 LINE
FIGURE 31. A SIMPLE ILLUSTRATION OF A DS3 SIGNAL BEING MAPPED INTO AND TRANSPORTED OVER THE SONET
NETWORK
DS3 Data
PPTTEE
SONET
Network
PPTTEE
DS3 Data
As mentioned above a DS3 or E3 signal will be asynchronously mapped into a SONET or SDH signal and then
transported over the SONET or SDH network. At the remote PTE this DS3 or E3 signal will be extracted (or
de-mapped) from this SONET or SDH signal, where it will then be routed to DS3 or E3 terminal equipment for
further processing.
In order to insure that this "de-mapped" DS3 or E3 signal can be routed to any industry-standard DS3 or E3
terminal equipment, without any complications or adverse effect on the network, the Telcordia and ITU-T
standard committees have specified some limits on both the Intrinsic Jitter and Wander that may exist within
these DS3 or E3 signals as they are de-mapped from SONET/SDH. As a consequence, all PTEs that maps
and de-mapped DS3/E3 signals into/from SONET/SDH must be designed such that the DS3 or E3 data that is
de-mapped from SONET/SDH by these PTEs must meet these Intrinsic Jitter and Wander requirements.
As mentioned above, the XRT75R03D can assist the System Designer (of SONET/SDH PTE) by insuring that
their design will meet these Intrinsic Jitter and Wander requirements.
This section of the data sheet will present the following information to the user.
• Some background information on Mapping DS3/E3 signals into SONET/SDH and de-mapping DS3/E3
signals from SONET/SDH.
• A brief discussion on the causes of jitter and wander within a DS3 or E3 signal that mapped into a SONET/
SDH signal, and is transported across the SONET/SDH Network.
• A brief review of these Intrinsic Jitter and Wander requirements in both SONET and SDH applications.
• A brief review on the Intrinsic Jitter and Wander measurement results (of a de-mapped DS3 or E3 signal)
whenever the XRT75R03D device is used in a system design.
• A detailed discussion on how to design with and configure the XRT75R03D device such that the end-system
will meet these Intrinsic Jitter and Wander requirements.
In a SONET system, the relevant specification requirements for Intrinsic Jitter and Wander (within a DS3 signal
that is mapped into and then de-mapped from SONET) are listed below.
• Telcordia GR-253-CORE Category I Intrinsic Jitter Requirements for DS3 Applications (Section 5.6), and
91