XRT75R03D_06 Datasheet, PDF (26/135 Pages) Exar Corporation – EXAR DATA SHEET FORMAT TEMPLATES

XRT75R03D
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCRONIZER
Microprocessor Serial INTERFACE - (HOST MODE)
REV. 1.0.4
PIN #
SIGNAL NAME
TYPE
DESCRIPTION
67
SClk/TCLKINV
I
Microprocessor Serial Interface -Serial Clock Input:
This input pin functions as the Clock Source for the Microprocessor Serial Inter-
face.
Each time the user wishes to perform a READ or WRITE operate with the on-
chip Command Registers via the Microprocessor Serial Interface, the user
MUST do the following.
• Assert the CS input pin by toggling it "Low", and
• Provide 16 Clock Periods to this particular input pin for each READ and
WRITE operation.
The Microprocessor Serial Interface will sample any data residing upon the SDI
input pin, upon the rising edge of this clock signal. Further, for READ opera-
tions, the Microprocessor Serial Interface will serially output the contents of a
target Command Register upon the falling edge of this clock signal.
NOTE: The maximum frequency of this particular clock signal is 10MHz.
66
CS/RCLKINV
I
Microprocessor Serial Interface - Chip Select Input:
This input pin should be pulled "Low" whenever a READ or WRITE operation is
to be executed to the on-chip Command Registers, via the Microprocessor
Serial Interface.
This input pin should remain "Low" until the READ or WRITE operation has
been completed. This input pin should be pulled "High" at all other times.
NOTE: If the XRT75R03D has been configured to operate in the Host Mode
then this input pin will function as the RCLKINV input pin.
71
INT/LOSMUT
O Microprocessor Serial Interface - Interrupt Request Output:
If the XRT75R03D has been configured to operate in the Host Mode, then this
pin becomes the Interrupt Request Output for the XRT75R03D.
During normal conditions, this output pin will be pulled "High". However, if the
user enables certain interrupts within the device, and if those conditions occur,
then the XRT75R03D will request an interrupt from the Microprocessor by tog-
gling this output pin "Low".
NOTES:
1. If the XRT75R03D is configured to operate in the Hardware Mode,
then this pin functions as the LOSMUT input pin.
2. This pin will remain "Low" until the Interrupt has been served.
101
RESET
I
Microprocessor Serial Interface - H/W RESET Input:
Pulsing this input "Low" causes the XRT75R03D to reset the contents of the on-
chip Command Registers to their default values. As a consequence, the
XRT75R03D will then also be operating in its default condition.
For normal operation pull this input pin to a logic "High".
NOTE: This input pin is internally pulled high.
POWER SUPPLY AND GROUND PINS
PIN #
PIN NAME
TYPE
77
RxAVDD_0
****
93
RxAVDD_1
86
RxAVDD_2
Receive Analog VDD
DESCRIPTION
22