XRT75R03D_06 Datasheet, PDF (75/135 Pages) Exar Corporation – EXAR DATA SHEET FORMAT TEMPLATES

REV. 1.0.4
XRT75R03D
THREE CHANNEL E3/DS3/STS-1 LINE
BIT 7
Unused
R/O
0
TABLE 26: ALARM STATUS REGISTER - CHANNEL 0 ADDRESS LOCATION = 0X03
Channel 1 Address Location = 0x0B
Channel 2 Address Location = 0x13
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Loss of PRBS
Pattern Sync
Digital LOS
Defect
Declared
Analog LOS
Defect
Declared
FL
(FIFO Limit)
Alarm
Declared
Receive LOL Receive LOS
Defect
Defect
Declared
Declared
Transmit
DMO
Condition
R/O
R/O
R/O
R/O
R/O
R/O
R/O
0
0
0
0
0
0
0
BIT NUMBER
NAME
7
Unused
6
Loss of PRBS Pat-
tern Lock
TYPE
R/O
R/O
DEFAULT
VALUE
DESCRIPTION
0
0 Loss of PRBS Pattern Lock Indicator:
This READ-ONLY bit-field indicates whether or not the
PRBS Receiver (within the Receive Section of Channel 0) is
declaring PRBS Lock within the incoming PRBS pattern.
If the PRBS Receiver detects a very large number of bit-
errors within its incoming data-stream, then it will declare
the Loss of PRBS Lock Condition.
Conversely, if the PRBS Receiver were to detect its pre-
determined PRBS pattern with the incoming DS3, E3 or
STS-1 data-stream, (with little or no bit errors) then the
PRBS Receiver will clear the Loss of PRBS Lock condition.
0 - Indicates that the PRBS Receiver is currently declaring
the PRBS Lock condition within the incoming DS3, E3 or
STS-1 data-stream.
1 - Indicates that the PRBS Receiver is currently declaring
the Loss of PRBS Lock condition within the incoming DS3,
E3 or STs-1 data-stream.
NOTE: This register bit is only valid if all of the following are
true.
a. The PRBS Generator block (within the Transmit
Section of the Chip is enabled).
b. The PRBS Receiver is enabled.
c. The PRBS Pattern (that is generated by the PRBS
Generator) is somehow looped back into the Receive
Path (via the Line-Side) and in-turn routed to the
receive input of the PRBS Receiver.
71