English
Language : 

20-101-1051 Datasheet, PDF (90/165 Pages) List of Unclassifed Manufacturers – C-Programmable Core Module with NAND Flash Mass Storage and Ethernet
• Module Extension Headers—The complete pin set of the RCM3365/RCM3375
module is duplicated at headers J8 and J9. Developers can solder wires directly into the
appropriate holes, or, for more flexible development, 2 × 17 header strips with a 0.1"
pitch can be soldered into place. See Figure B-4 for the header pinouts.
• Digital I/O—Four digital inputs are available on screw-terminal header J6. See
Figure B-4 for the header pinouts.
• RS-232—Two 3-wire serial ports or one 5-wire RS-232 serial port are available on the
Prototyping Board at screw-terminal header J14.
• RS-485—One RS-485 serial port is available on the Prototyping Board at screw-termi-
nal header J14.
• Quadrature Decoder—Four quadrature decoder inputs (PF0–PF3) from the Rabbit
3000 chip are available on screw-terminal header J5. See Figure B-4 for the header
pinouts.
• H-Bridge Motor Driver—Two pairs of H-bridge motor drivers are supported using
screw-terminal headers J3 and J4 on the Prototyping Board for stepper-motor control.
See Figure B-4 for the header pinouts.
• RabbitNet Port—One RS-422 RabbitNet port (shared with the serial flash interface) is
available to allow RabbitNet peripheral cards to be used with the RCM3365/RCM3375
and the Prototyping Board.
• Serial Flash Interface—One serial flash interface (shared with the RabbitNet port) is
available to allow Rabbit’s SF1000 series serial flash to be used on the Prototyping
Board.
84
RabbitCore RCM3365/RCM3375