20-101-1051 Datasheet, PDF (76/165 Pages) List of Unclassifed Manufacturers – C-Programmable Core Module with NAND Flash Mass Storage and Ethernet

Table A-1 lists the electrical, mechanical, and environmental specifications for the RCM3365/
RCM3375.
Table A-1. RabbitCore RCM3365/RCM3375 Specifications
Parameter
RCM3365
RCM3375
Microprocessor
Low-EMI Rabbit^® 3000 at 44.2 MHz
EMI Reduction
Spectrum spreader for reduced EMI (radiated emissions)
Ethernet Port
10/100Base-T, RJ-45, 3 LEDs
SRAM
512K program (fast SRAM) + 512K data
Flash Memory
(program)
512K
Flash Memory
(mass data
storage)
32MB (fixed)^*
+xD-Picture Card
with up to 128MB
(NAND flash)
xD-Picture Card
with up to 128MB
(NAND flash)
LED Indicators
ACT (activity)
LINK (link)
SPEED (on for 100Base-T Ethernet connection)
FM (flash memory, NAND)
USR (user-programmable)
Backup Battery
Connection for user-supplied backup battery
(to support RTC and data SRAM)
General-Purpose
I/O
52 parallel digital I/0 lines:
• 44 configurable I/O
• 4 fixed inputs
• 4 fixed outputs
Additional Inputs
Startup mode (2), reset in
Additional
Outputs
Status, reset out
External I/O Bus
Can be configured for 8 data lines and
5 address lines (shared with parallel I/O lines), plus I/O read/write
Six 3.3 V, CMOS-compatible ports (shared with I/O)
• all 6 configurable as asynchronous (with IrDA)
Serial Ports
• 4 configurable as clocked serial (SPI)
• 2 configurable as SDLC/HDLC
• 1 asynchronous serial port dedicated for programming
Serial Rate
Maximum asynchronous baud rate = CLK/8
Slave Interface
A slave port allows the RCM3365/RCM3375 to be used as an
intelligent peripheral device slaved to a master processor, which
may either be another Rabbit 3000 or any other type of processor
Real-Time Clock
Yes
Timers
Ten 8-bit timers (6 cascadable, 3 reserved for internal peripherals),
one 10-bit timer with 2 match registers
70
RabbitCore RCM3365/RCM3375