20-101-1051 Datasheet, PDF (116/165 Pages) List of Unclassifed Manufacturers – C-Programmable Core Module with NAND Flash Mass Storage and Ethernet

3. Fasten the unit with the four 4-40 screws and washers included with the LCD/keypad
module. If your panel is thick, use a 4-40 screw that is approximately 3/16" (5 mm)
longer than the thickness of the panel.
Bezel/Gasket
Panel
C1
Q1
DISPLAY BOARD
U1
U2
U3
C4
C2
C3
D1
J1
R1
R2
R3
R4
R5
R6
R7
R8
Q2
Q3
Q4
Q5
Q6
Q7
Q8
C5
KP1
J2
RN1
U4
J3
C6
Figure C-9. LCD/Keypad Module Mounted in Panel (rear view)
Carefully tighten the screws until the gasket is compressed and the plastic bezel face-
plate is touching the panel.
Do not tighten each screw fully before moving on to the next screw. Apply only one or
two turns to each screw in sequence until all are tightened manually as far as they can
be so that the gasket is compressed and the plastic bezel faceplate is touching the panel.
110
RabbitCore RCM3365/RCM3375