MC3410 Datasheet, PDF (47/75 Pages) NXP Semiconductors – 10-Bit high-speed multiplying D/A converter

MC3410 3-Axis Accelerometer
Datasheet
11.5 MODE: REGISTER
The MODE register controls the active operating state of the device. This register can be
written from either operational state (STANDBY or WAKE).
Addr Name Description
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
POR R/
Value W
0x07 MODE Mode Register IAH
IPP
Resv^* Resv^* Resv^*
0^*
OPCON OPCON
[1]
[0]
0x03 W
NOTE*: Software must always write a zero ‘0’ to Bit 2. Bits 3, 4 and 5 are reserved.
OPCON
[1:0]
IPP
IAH
00: Reserved
01: Move to WAKE state and remain there
10: Reserved
11: Move to STANDBY state and remain
there (STANDBY is the default POR state)
0: Interrupt pin INTN is open drain (default)
and requires an external pull-up to AVDD.
1: Interrupt pin INTN is push-pull. No
external pull-up resistor should be
installed.
0: Interrupt pin INTN is active low
1: Interrupt pin INTN is active high
Table 27. Mode Register Functionality
Set Device Operational State.
WAKE or STANDBY
Interrupt Push Pull
Interrupt Active High
mCube Proprietary.
APS-048-0010v2.2
© 2014 mCube Inc. All rights reserved.
47 / 75