MC3410 Datasheet, PDF (18/75 Pages) NXP Semiconductors – 10-Bit high-speed multiplying D/A converter

MC3410 3-Axis Accelerometer
Datasheet
undesired high frequency components. Related to this LPF setting is the GINT interrupt rate,
which can be modified to occur based upon the LPF roll-off frequency, rather than the sample
rate (fixed at 1024 samples / second). See Section 8.2 GINT Interrupt for more on this option.
The cutoff points for the LPF can be set from 8Hz to 512 Hz. These, and the controls for the
GINT rate, are described in Section 11.12 OUTCFG: Output Configuration Register.
5.2 OFFSET AND GAIN CALIBRATION
Digital offset and gain calibration can be performed on the sensor, if necessary, in order to
reduce the effects of post-assembly influences and stresses which may cause the sensor
readings to be offset from their factory values. The register controls are described in Sections
11.13 through 11.18.
mCube Proprietary.
APS-048-0010v2.2
© 2014 mCube Inc. All rights reserved.
18 / 75