W78IRD2 Datasheet, PDF (40/76 Pages) Winbond – 8-BIT MICROCONTROLLER

W78IRD2
Transmission begins when data is written to SBUF but is synchronized with the roll-over of Timer 1
(divided by 16 or 32, as configured) and not the write signal. The W78IRD2 waits until the next roll-over
of Timer 1 (divided by 16 or 32) before the data is put on TxD. The next bit is placed on TxD after the
next rollover. After all eight bits of data are transmitted, the stop bit is transmitted. Finally, the TI flag is
set, at the tenth rollover after the write signal.
Reception is enabled only if REN is high. The W78IRD2 samples the RxD line at a rate of 16 times the
selected baud rate, looking for a falling edge. When a falling edge is detected on the RxD pin, Timer 1
(divided by 16 or 32) is immediately reset to align the bit boundaries better, and the serial port starts
receiving data. The 16 states of the counter effectively divide the time into 16 slices, and bit detection is
done on a best-of-three basis using the eighth, ninth and tenth states. If the start bit is invalid (1),
reception is aborted, and the serial port resumes looking for a falling edge on RxD. If the start bit is
valid, the eight data bits are shifted in. Then, if
(1) RI = 0 and
(2) SM2 = 0 or the stop bit = 1,
the stop bit is put into RB8, the data is put in SBUF, and RI is set. Otherwise, the received frame may
be lost. In the middle of the stop bit, the W78IRD2 resumes looking for falling edges on RxD.
10.3 MODE 2
Mode 2 is a full-duplex, asynchronous mode. Serial communication frames are made up of eleven bits
transmitted on TXD and received on RXD. The eleven bits consist of a start bit (0), eight data bits (LSB
first), a programmable ninth bit (TB8) and a stop bit (1). The ninth bit is read into and transmitted from
RB8. The baud rate is either 1/32 or 1/64 of the oscillator frequency, and the 1/32 or 1/64 factor is
determined by the SMOD bit in PCON SFR. The functional diagram is shown below.
1/2 fosc
2
SMOD = 0 1
SAMPLE
RXD
Write to
SBUF
TB8
Internal
Data Bus
16
16
1-TO-0
DETECTOR
TX START
TX CLOCK
TX
SHIFT
TI
SERIAL
CONTROLLER _RI
RX CLOCK
RX START
LOAD
SBUF
RX SHIFT
BIT
DETECTOR
D8
STOP
PARIN
START
LOAD
SOUT
CLOCK
Transmit Shift Register
TXD
Serial Port
Interrupt
CLOCK
PAROUT
SBUF
SIN
D8
RB8
Receive Shift Register
Read
SBUF
Internal
Data
Bus
Figure 10-3 Serial Port Mode 2
Transmission begins when data is written to SBUF but is synchronized with the roll-over of the counter
(divided by 32 or 64, as configured) and not the write signal. The W78IRD2 waits until the next roll-over
- 40 -