M0518 Datasheet, PDF (31/72 Pages) List of Unclassifed Manufacturers – 36/68 Kbytes flash, 8K bytes SRAM

NuMicro M0518 Series Datasheet
6.2.6.1 Exception Model and System Interrupt Map
The following table lists the exception model supported by NuMicro M0518 series. Software can
set four levels of priority on some of these exceptions as well as on all interrupts. The highest
user-configurable priority is denoted as “0” and the lowest priority is denoted as “3”. The default
priority of all the user-configurable interrupts is “0”. Note that priority “0” is treated as the fourth
priority on the system, after three system exceptions “Reset”, “NMI” and “Hard Fault”.
Exception Name
Reset
NMI
Hard Fault
Reserved
SVCall
Reserved
PendSV
SysTick
Interrupt (IRQ0 ~ IRQ31)
Vector Number
1
2
3
4 ~ 10
11
12 ~ 13
14
15
16 ~ 47
Table 6-2 Exception Model
Priority
-3
-2
-1
Reserved
Configurable
Reserved
Configurable
Configurable
Configurable
Vector
Number
Interrupt Number
(Bit In Interrupt ^{Interrupt Name}
Registers)
Source
Module
Interrupt Description
1 ~ 15
-
-
-
System exceptions
16
0
BOD_INT
Brown-out Brown-out low voltage detected interrupt
17
1
WDT_INT
WDT Watchdog Timer interrupt
18
2
EINT0
GPIO External signal interrupt from PB.14 pin
19
3
EINT1
GPIO External signal interrupt from PB.15 pin
20
4
GPAB_INT
GPIO External signal interrupt from PA[15:0]/PB[13:0]
21
5
GPCDEF_INT
GPIO External interrupt from PC[15:0]/PD[15:0]/PE[15:0]/PF[8:0]
22
6
-
-
Reserved
23
7
-
-
Reserved
24
8
TMR0_INT
TMR0 Timer 0 interrupt
25
9
TMR1_INT
TMR1 Timer 1 interrupt
26
10
TMR2_INT
TMR2 Timer 2 interrupt
27
11
TMR3_INT
TMR3 Timer 3 interrupt
28
12
UART02_INT UART0/2 UART0 and UART2 interrupt
29
13
UART1_INT
UART1 UART1 interrupt
30
14
SPI0_INT
SPI0 SPI0 interrupt
Feb 08, 2017
Page 31 of 72
Revision 1.01