N2893A Datasheet, PDF (16/29 Pages) List of Unclassifed Manufacturers – InfiniiVision Oscilloscope Probes and Accessories

16 | Keysight | InfiniiVision Oscilloscope Probes and Accessories - Data Sheet
Single-ended Active Probes (continued) N7020A
power rail probe
–  2-GHz single-ended active probe for power rail noise measurement
–  1:1 attenuation ratio ensures low noise signal measurement
–  ±24V of probe offset range enables effective elimination of DC component of a
power supply.
The N7020A power rail probe is a low noise, large offset range oscilloscope probe that
enables users to measure small signals riding on top of DC power rails.
–  Low noise: The N7020A power rail probe is a 1:1 attenuation ratio active probe. As
a general rule, the higher a probes attenuation ratio, the nosier the signal will be on
the oscilloscope.
–  Large offset range: The N7020A power rail probe provides ±24V of probe offset. This
enables users to center the signal on screen while placing the oscilloscope at its
maximum vertical sensitivity and zoom in on the signal.
–  Low DC loading: The N7020A power rail probe has 50 kΩ input impedance at DC,
minimizing the probe’s DC loading of the power rail.
–  Large input dynamic range: The N7020A power rail probe’s ±850 mV input dynamic
range means that users can measure up to ±850 mV deviations of their DC supplies.
This is very useful for measuring programmable supplies like those used in micro-
controller power saving modes.
Characteristics and specifications
Probe bandwidth (-3dB)
2 GHz
Attenuation ratio
1:1
Offset range
Input impedance at DC
±24 V
50 kΩ
At >1 MHz
Input dynamic range
Probe noise
Included accessories
Max number of probes supported
by InfiniiVision
Compatible InfiniiVision
oscilloscopes
50 Ω
± 850 mV
10% of oscilloscope noise
N7021A coaxial probe head (qty. 3), N7022A SMA main cable
4
4000 X-Series with software rev 4.0 or higher
For more information about the N7020A power rail probe, check out the Keysight data
sheet with the publication number 5992-0141EN.