EVK1100 Datasheet, PDF (9/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Hardware preparation
Make sure that the connector is firmly seated on the footprint, and start by soldering the corners.
Figure 3-4. Soldering the corners
When all corners are soldered, check that connector is still firmly seated. It is still possible to push the
connector down and re-heat corner pins if you need to adjust a bit.
Figure 3-5. Soldered corner pin
AVR ONE! Quick-start Guide
3-3
32103C–AVR ONE!–02/10