EVK1100 Datasheet, PDF (34/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Create demo application
6.2.3
Target MCU Chip erase
If the EVK1100 evaluation board is brand new, or if it still contains the original demo application (Control
Panel Demo), the FLASH lock-bits need to be cleared. Right-click on the AVR ONE! In the AVR32 Tar-
get view and select Chip Erase.
WARNING! This process will erase the original demo application programmed at the factory. After this
operation the EVK1100 evaluation board will be completely empty. If you need to keep the original appli-
cation, you should not perform this operation.
If you would like to use your EVK1100 for this example, it is not difficult to restore the original “Control
Panel Demo application”. All you have to do is to build the “Control Panel Demo example” enclosed with
AVR32 Studio.
You should now perform the Chip Erase operation.
Figure 6-11. Chip erase operation
AVR ONE! Quick-start Guide
6-7
32103C–AVR ONE!–02/10