EVK1100 Datasheet, PDF (2/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Table of Contents (Continued)
Section 1
Introduction................................................................................................................. 1-1
1.1 General .............................................................................................................................. 1-1
1.2 Requirements..................................................................................................................... 1-1
Section 2
Quick-start guide (short version) ................................................................................ 2-1
2.1 Install Hardware and software ........................................................................................... 2-1
2.2 Create a demonstration project ......................................................................................... 2-1
2.3 Configure target MCU for a debug session using trace ..................................................... 2-1
2.4 Start the debug session and configure AVR32 Studio 2.5 for trace................................... 2-2
2.5 Start the trace debug session ............................................................................................ 2-2
Section 3
Hardware preparation................................................................................................. 3-1
Section 4
Software Installation ................................................................................................... 4-1
4.1 Download the software ...................................................................................................... 4-1
4.2 Download the two installation files to your disk.................................................................. 4-2
4.3 Install AVR32 GNU Toolchain............................................................................................ 4-2
4.4 Install AVR32 Studio 2.5 .................................................................................................... 4-8
4.5 Connect the AVR ONE! to power and USB host ............................................................. 4-11
4.6 Install AVR ONE! Driver................................................................................................... 4-12
Section 5
5.1 Connect the AVR ONE! to the EVK1100 ........................................................................... 5-1
5.2 Connect the EVK1100 to power......................................................................................... 5-2
Section 6
Create demo application ............................................................................................ 6-1
6.1 Start AVR32 Studio............................................................................................................ 6-1
6.2 Configure adapter and target ............................................................................................. 6-2
6.2.1 Add and configure the adapter (AVR ONE!)........................................................ 6-3
6.2.2 Configure target board and MCU......................................................................... 6-5
6.2.3 Target MCU Chip erase....................................................................................... 6-7
6.3 Create a demonstration project ......................................................................................... 6-8
6.4 Configure AVR32 Studio for a debug session using trace............................................... 6-11
6.4.1 Create a new debug launch configuration ......................................................... 6-12
6.4.2 Configure the target trace module for program trace......................................... 6-13
6.4.3 Configure the target trace module for data trace ............................................... 6-16
6.5 Start a debug session and configure the debugger for trace ........................................... 6-17
AVR ONE! Quick-start Guide
i
32103C–AVR ONE!–02/10