EVK1100 Datasheet, PDF (43/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

6.4.3
Create demo application
Configure the target trace module for data trace
We would like to keep an eye on one of our variables. To do this, we configure a data trace range. In our
case, we want a trace message each time the program writes to a variable called display.
Figure 6-24. Memory access type
Set Memory access type to write.
Figure 6-25. Data trace boundaries
Select memory location for lower and upper boundaries.
Figure 6-26. Variable address selection dialogue
Select the start and stop addresses for the data range. Use the Address selection dialogue, or type the
addresses.
AVR ONE! Quick-start Guide
6-16
32103C–AVR ONE!–02/10