EVK1100 Datasheet, PDF (23/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Software Installation
4.6 Install AVR ONE! Driver
When the AVR ONE! is powered up and connected to the PC for the first time, the proper USB driver
must be installed. Since the PC is keeping track of the serial number of each USB device, this will hap-
pen every time a new AVR ONE! is connected to the PC, even if the driver is the same as for all other
AVR ONE!s that have been connected previously. This is a property of the operating system, and is not
controlled by any Atmel software installed.
Figure 4-20. “New hardware” notification pop-up
Figure 4-21. AVR ONE! Hardware installation wizard
When the hardware installation wizard pops up, select No, not this time and click Next.
AVR ONE! Quick-start Guide
4-12
32103C–AVR ONE!–02/10