EVK1100 Datasheet, PDF (7/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Section 3
Hardware preparation
In case you have an evaluation kit without the MICTOR38 connector, you need to install one. In case the
connector is already mounted, you can skip this chapter.
To be able to connect to the evaluation board AUX port, you need to solder a connector to the board.
The AVR ONE! Kit contains one MICTOR38 connector for this purpose. If you need more connectors for
other kits, or your own designs, you can buy more connectors from Atmel, or Tyco Electronics/AMP.
The Tyco Electronics/AMP Part number is 2-5767004-2.
To install the MICTOR38 connector, you only need a fine-tipped soldering iron, a small piece of fine sol-
der (0,3mm is OK), and some extra flux. Also remember to provide proper ventilation to prevent inhaling
the fumes from the flux.
The soldering guide shows the EVK1100, but is applicable for all other kits that needs a MICTOR38 con-
nector (like the EVK1101).
Figure 3-1. Required hardware and tools for installation of Mictor38
AVR ONE! Quick-start Guide
3-1
32103C–AVR ONE!–02/10