EVK1100 Datasheet, PDF (8/59 Pages) ATMEL Corporation – Install the MICTOR38 connector on the EVK1100 board

Unpack the Mictor38 connector and remove the pick-and-place pad
Figure 3-2. Remove the pick-and-place pad
Hardware preparation
Place the connector onto the footprint on the evaluation board. Make sure that the guide tab beneath the
connector fits into the guide hole in the PCB.
Add a fair amount of flux. The extra flux is very important for a good result. It is also very important to
keep the tip of the soldering iron clean while mounting the connector.
Too thick solder, too little flux or solder-blobs on the tip of the soldering iron will give bad connections or
short circuits.
Figure 3-3. Place Mictor38 and apply flux
AVR ONE! Quick-start Guide
3-2
32103C–AVR ONE!–02/10