|
SAMA5D3_14 Datasheet, PDF (2/1840 Pages) ATMEL Corporation – ARM-based Embedded MPU | |||
|
◁ |
1. Features
ï¬ Core
ï¬ ARM® Cortex®-A5 Processor with ARM v7-A Thumb2® Instruction Set
ï¬ CPU Frequency up to 536 MHz
ï¬ 32 Kbyte Data Cache, 32 Kbyte Instruction Cache, Virtual Memory System Architecture (VMSA)
ï¬ Fully Integrated MMU and Floating Point Unit (VFPv4)
ï¬ Memories
ï¬ One 160 Kbyte Internal ROM Single-cycle Access at System Speed, Embedded Boot Loader: Boot on 8-bit
NAND Flash, SDCard, eMMC, serial DataFlash®, selectable Order
ï¬ One 128 Kbyte Internal SRAM, Single-cycle Access at System Speed
ï¬ High Bandwidth 32-bit Multi-port Dynamic RAM Controller supporting 512 Mbyte 8 bank
DDR2/LPDDR/LPDDR2 with datapath scrambling
ï¬ Independent Static Memory Controller with datapath scrambling and SLC/MLC NAND Support with up to
24-bit Error Correcting Code (PMECC)
ï¬ System running up to 166 MHz
ï¬ Reset Controller, Shut Down Controller, Periodic Interval Timer, Watchdog Timer and Real-time Clock
ï¬ Boot Mode Select Option, Remap Command
ï¬ Internal Low-power 32 kHz RC Oscillator and Fast 12 MHz RC Oscillator
ï¬ Selectable 32768 Hz Low-power Oscillator and 12 MHz Oscillator
ï¬ One 400 to 1000 MHz PLL for the System and one PLL at 480 MHz optimized for USB High Speed
ï¬ 39 DMA Channels including two 8-channel 64-bit Central DMA Controllers
ï¬ 64-bit Advanced Interrupt Controller
ï¬ Three Programmable External Clock Signals
ï¬ Programmable Fuse Box with 256 fuse bits, 192 of them available for Customer
ï¬ Low Power Management
ï¬ Shut Down Controller
ï¬ Battery Backup Registers
ï¬ Clock Generator and Power Management Controller
ï¬ Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
ï¬ Peripherals
ï¬ LCD TFT Controller with Overlay, Alpha-blending, Rotation, Scaling and Color Space Conversion
ï¬ ITU-R BT. 601/656 Image Sensor Interface
ï¬ Three HS/FS/LS USB Ports with On-Chip Transceivers
ï¬ One Device Controller
ï¬ One Host Controller with Integrated Root Hub (3 Downstream Ports)
ï¬ One 10/100/1000 Mbps Gigabit Ethernet MAC Controller (GMAC) with IEEE1588 support
ï¬ One 10/100 Mbps Ethernet MAC Controller (EMAC)
ï¬ Two CAN Controllers with 8 Mailboxes, fully Compliant with CAN 2.0 Part A and 2.0 Part B
ï¬ Softmodem Interface
ï¬ Three High Speed Memory Card Hosts (eMMC 4.3 and SD 2.0)
ï¬ Two Master/Slave Serial Peripheral Interfaces
ï¬ Two Synchronous Serial Controllers
ï¬ Three Two-wire Interface up to 400 Kbit/s supporting I2C Protocol and SMBUS
ï¬ Four USARTs, two UARTs, one DBGU
ï¬ Two Three-channel 32-bit Timer/Counters
ï¬ One 4-channel 16-bit PWM Controller
SAMA5D3 Series [DATASHEET]
2
11121DâATARMâ03-Apr-14
|
▷ |