AK4343 Datasheet, PDF (83/98 Pages) Asahi Kasei Microsystems – Stereo DAC with HP/RCV/SPK-AMP

ASAHI KASEI
[AK4343]
1. Grounding and Power Supply Decoupling
The AK4343 requires careful attention to power supply and grounding arrangements. AVDD, DVDD and HVDD are
usually supplied from the system’s analog supply. If AVDD, DVDD and HVDD are supplied separately, the power-up
sequence is not critical. AVSS, DVSS and HVSS of the AK4343 should be connected to the analog ground plane. System
analog ground and digital ground should be connected together near to where the supplies are brought onto the printed
circuit board. Decoupling capacitors should be as near to the AK4343 as possible, with the small value ceramic capacitor
being the nearest.
2. Voltage Reference
VCOM is a signal ground of this chip. A 2.2µF electrolytic capacitor in parallel with a 0.1µF ceramic capacitor attached
to the VCOM pin eliminates the effects of high frequency noise. No load current may be drawn from the VCOM pin. All
signals, especially clocks, should be kept away from the VCOM pin in order to avoid unwanted coupling into the
AK4343.
3. Analog Inputs
The Line and MIN inputs are single-ended. The input signal range scales with nominally at 0.06 x AVDD Vpp(typ)
@MGAIN1-0 bits = “01”, 0.03 x AVDD Vpp(typ) @MGAIN1-0 bits = “10”, 0.015 x AVDD Vpp(typ) @MGAIN1-0
bits = “11” or 0.6 x AVDD Vpp(typ) @MGAIN1-0 bits = “00” for the Line input and 0.6 x AVDD Vpp (typ) for the MIN
input, centered around the internal common voltage (0.45 x AVDD). Usually the input signal is AC coupled using a
capacitor. The cut-off frequency is fc = (1/2πRC). The AK4343 can accept input voltages from AVSS to AVDD.
4. Analog Outputs
The input data format for the DAC is 2’s complement. The output voltage is a positive full scale for 7FFFH(@16bit) and
a negative full scale for 8000H(@16bit). Stereo Line Output and Receiver Output are centered at 0.45 x AVDD. The
Headphone-Amp and Speaker-Amp outputs are centered at HVDD/2.
MS0478-E-01
- 83 -
2006/10