BQ25120A Datasheet, PDF (47/67 Pages) Texas Instruments – Low IQ Highly Integrated Battery Charge Management Solution for Wearables and IoT

www.ti.com
10 Application and Implementation
bq25120A
SLUSD08 – MAY 2017
NOTE
Information in the following applications sections is not part of the TI component
specification, and TI does not warrant its accuracy or completeness. TI's customers are
responsible for determining suitability of components for their purposes. Customers should
validate and test their design implementation to confirm system functionality.
10.1 Application Information
A typical design is shown in Figure 37. This design uses the BQ25120A with external resistors for ILIM,
IPRETERM, and ISET. These are not needed if these values are set with a host controller through I²C
commands. This design also shows the TS resistors, which is also optional.
When powering up in default mode the battery voltage is the default for the part (4.2 V), the SYS output is the
default (1.8 V). External resistors set the charge current to 40 mA, the termination current to 10% (4 mA), and
the input current limit to 100 mA. If the I²C interface is used the part goes to the internal default settings until
changed by the host.
10.2 Typical Application
Figure 37. Typical Application Circuit
Copyright © 2017, Texas Instruments Incorporated
Product Folder Links: bq25120A
Submit Documentation Feedback
47