TL16C752D-Q1 Datasheet, PDF (44/53 Pages) Texas Instruments – Dual UART With 64-Byte FIFO

TL16C752D-Q1
SLLSET4 – FEBRUARY 2016
9 Application and Implementation
www.ti.com
NOTE
Information in the following applications sections is not part of the TI component
specification, and TI does not warrant its accuracy or completeness. TI’s customers are
responsible for determining suitability of components for their purposes. Customers should
validate and test their design implementation to confirm system functionality.
9.1 Application Information
The typical implementation is to use the TL16C752D-Q1 as a dual RS-232 interface, which is intended to operate
with a 5-V microprocessor.
9.2 Typical Application
Voltage
Regulator
Microcontroller
Data
Address
IOW, IOR, Reset
Chip select
Int and RDY
TL16C752D
UART Ch 1
MAX232
UART Ch 2
MAX232
Xtal1
Xtal2 (optional)
Crystal/
Oscillator
1.8432 MHz
Figure 39. Typical Application Dual RS-232 Interface
9.2.1 Design Requirements
Include the recommended operating conditions for 3.3 V provided by the controller board, but with the input clock
equal to 1.8432 MHz, and include the operating free-air temperature conditions. The controller must have two 8-
bit ports, one for the control signals and another for the I/O data. A third port is optional in order to monitor the
interruptions and TX/RX ready signals (if it is needed).
44
Submit Documentation Feedback
Product Folder Links: TL16C752D-Q1
Copyright © 2016, Texas Instruments Incorporated