BQ25600 Datasheet, PDF (42/66 Pages) Texas Instruments – I2C Controlled 3.0-A, Single Cell Battery Charger With up-to 40-V Overvoltage Protection Controller for High-Input Voltage and Narrow Voltage DC (NVDC) Power Path Management

bq25600, bq25600D
SLUSCJ4 – JUNE 2017
www.ti.com
7.4.8 REG07
Bit Field
7 IINDET_EN
6 TMR2X_EN
5 BATFET_DIS
4
JEITA_VSET
(45C-60C)
3 BATFET_DLY
2 BATFET_RST_EN
1 VDPM_BAT_TRACK[1]
0 VDPM_BAT_TRACK[0]
POR
0
1
0
0
1
1
0
0
Table 14. REG07 Field Descriptions
Type
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset
Description
Comment
by REG_RST
by Watchdog
0 – Not in D+/D– detection (or
PSEL detection);
1 – Force D+/D– detection
Default: Not in DPDM detection (0)
Note: For PSEL part, reads PSEL
pin value
0 – Disable
by REG_RST 1 – Safety timer slowed by 2X
by Watchdog during input DPM (both V and I) or
JEITA cool, or thermal regulation
0 – Allow Q4 turn on, 1 – Turn off
by REG_RST Q4 with t_{BATFET_DLY} delay time
(REG07[3])
Default: Allow Q4 turn on(0)
by REG_RST
by Watchdog
0 – Set Charge Voltage to 4.1V (
max),
1 – Set Charge Voltage to VREG
by REG_RST
0 – Turn off BATFET immediately
when BATFET_DIS bit is set
1 –Turn off BATFET after
t_{BATFET_DLY} (typ. 10 s) when
BATFET_DIS bit is set
Default: 1
Turn off BATFET after t_{BATFET_DLY}
(typ. 10 s) when BATFET_DIS bit
is set
by REG_RST 0 – Disable BATFET reset function Default: 1
by Watchdog 1 – Enable BATFET reset function Enable BATFET reset function
by REG_RST 00 - Disable function (VINDPM set
by register)
01 - VBAT + 200mV
by REG_RST _{10 - VBAT + 250mV}
11 - VBAT + 300mV
Sets VINDPM to track BAT
voltage. Actual VINDPM is higher
of register value and VBAT +
VDPM_BAT_TRACK
LEGEND: R/W = Read/Write; R = Read only
42
Submit Documentation Feedback
Product Folder Links: bq25600 bq25600D
Copyright © 2017, Texas Instruments Incorporated