BQ25600 Datasheet, PDF (33/66 Pages) Texas Instruments – I2C Controlled 3.0-A, Single Cell Battery Charger With up-to 40-V Overvoltage Protection Controller for High-Input Voltage and Narrow Voltage DC (NVDC) Power Path Management

www.ti.com
bq25600, bq25600D
SLUSCJ4 – JUNE 2017
7.3.11.5 Slave Address and Data Direction Bit
After the START, a slave address is sent. This address is 7 bits long followed by the eighth bit as a data direction
bit (bit R/W). A zero indicates a transmission (WRITE) and a one indicates a request for data (READ).
SDA
SCL
S
START
1-7
ADDRESS
8
9
1-7
8
9
R / W ACK
DATA
ACK
Figure 24. Complete Data Transfer
1-7
8
DATA
9
ACK
P
STOP
7.3.11.6 Single Read and Write
If the register address is not defined, the charger IC send back NACK and go back to the idle state.
1
7
1
1
S Slave Address 0 ACK
8
Reg Addr
1
ACK
8
Data to Addr
1
1
ACK P
Figure 25. Single Write
1
7
1
1
S Slave Address 0 ACK
8
Reg Addr
1
1
ACK S
7
Slave Addr
1
1
1 ACK
Figure 26. Single Read
8
Data
1
1
NCK P
7.3.11.7 Multi-Read and Multi-Write
The charger device supports multi-read and multi-write on REG00 through REG0B.
1
7
1
1
S Slave Address 0 ACK
8
Reg Addr
1
ACK
8
Data to Addr
1
8
1
ACK Data to Addr + N ACK
Figure 27. Multi-Write
8
1
1
Data to Addr + N ACK P
1
7
1
1
S Slave Address 0 ACK
8
Reg Addr
1
1
7
1
1
ACK S Slave Address 1 ACK
8
Data @ Addr
1
8
1
ACK Data @ Addr + 1 ACK
Figure 28. Multi-Read
8
1
1
Data @ Addr + N NCK P
Copyright © 2017, Texas Instruments Incorporated
Product Folder Links: bq25600 bq25600D
Submit Documentation Feedback
33