DS90UR910-Q1 Datasheet, PDF (33/34 Pages) Texas Instruments – 10 - 75 MHz 24-bit Color FPD-Link II to CSI-2 Converter

www.ti.com
DS90UR910-Q1
SNLS414D – JUNE 2012 – REVISED JULY 2015
Layout Guidelines (continued)
9.1.5 LVDS Interconnect Guidelines
See AN-1108 and AN-905 for full details.
• Use 100Ω coupled differential pairs
• Use the S/2S/3S rule in spacings
– S = space between the pair
– 2S = space between pairs
– 3S = space to LVCMOS signal
• Minimize the number of Vias and skew within the pair
• Use differential connectors when operating above 500 Mbps line speed
• Maintain balance of the traces
• Terminate as close to the TX outputs and RX inputs as possible
Additional general guidance can be found in the LVDS Owner’s Manual - available in PDF format from the Texas
Instruments web site at: www.ti.com/lvds
10 Device and Documentation Support
10.1 Trademarks
TRI-STATE is a registered trademark of National Semiconductor Corporation.
All other trademarks are the property of their respective owners.
10.2 Electrostatic Discharge Caution
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
10.3 Glossary
SLYZ022 — TI Glossary.
This glossary lists and explains terms, acronyms, and definitions.
11 Mechanical, Packaging, and Orderable Information
The following pages include mechanical, packaging, and orderable information. This information is the most
current data available for the designated devices. This data is subject to change without notice and revision of
this document. For browser-based versions of this data sheet, refer to the left-hand navigation.
Copyright © 2012–2015, Texas Instruments Incorporated
Product Folder Links: DS90UR910-Q1
Submit Documentation Feedback
33