MSP430FR5969_14 Datasheet, PDF (114/132 Pages) Texas Instruments – Mixed-Signal Microcontrollers

MSP430FR5969, MSP430FR59691, MSP430FR5968, MSP430FR5967
MSP430FR5959, MSP430FR5958, MSP430FR5957
MSP430FR5949, MSP430FR5948, MSP430FR5947, MSP430FR59471
SLAS704B – OCTOBER 2012 – REVISED MAY 2014
www.ti.com
The reference voltage must be a stable voltage for accurate measurements. The capacitor values that are
selected in the general guidelines filter out the high- and low-frequency ripple before the reference voltage
enters the device. In this case, the 10-µF capacitor is used to buffer the reference pin and filter any low-
frequency ripple. A bypass capacitor of 4.7 µF is used to filter out any high frequency noise.
7.2.1.3 Detailed Design Procedure
For additional design information, see the application report Designing With the MSP430FR58xx, FR59xx,
FR68xx, and FR69xx ADC (SLAA624).
7.2.1.4 Layout Guidelines
Component that are shown in the partial schematic (see Figure 7-5) should be placed as close as possible
to the respective device pins. Avoid long traces, because they add additional parasitic capacitance,
inductance, and resistance on the signal.
Avoid routing analog input signals close to a high-frequency pin (for example, a high-frequency PWM),
because the high-frequency switching can be coupled into the analog signal.
If differential mode is used for the ADC12_B, the analog differential input signals must be routed closely
together to minimize the effect of noise on the resulting signal.
114 Applications, Implementation, and Layout
Copyright © 2012–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: MSP430FR5969 MSP430FR59691 MSP430FR5968 MSP430FR5967 MSP430FR5959
MSP430FR5958 MSP430FR5957 MSP430FR5949 MSP430FR5948 MSP430FR5947 MSP430FR59471