AM1705_15 Datasheet, PDF (38/165 Pages) Texas Instruments – AM1705 ARM® Microprocessor

AM1705
SPRS657E – FEBRUARY 2010 – REVISED JUNE 2014
6 Peripheral Information and Electrical Specifications
6.1 Parameter Information
6.1.1 Parameter Information Device-Specific Information
www.ti.com
Tester Pin Electronics
Data Sheet Timing Reference Point
42 Ω
4.0 pF
3.5 nH
1.85 pF
Transmission Line
Z0 = 50 Ω
(see note)
Output
Under
Test
Device Pin
(see note)
A. The data sheet provides timing at the device pin. For output timing analysis, the tester pin electronics and its
transmission line effects must be taken into account. A transmission line with a delay of 2 ns or longer can be used to
produce the desired transmission line effect. The transmission line is intended as a load only. It is not necessary to
add or subtract the transmission line delay (2 ns or longer) from the data sheet timings.
Input requirements in this data sheet are tested with an input slew rate of < 4 Volts per nanosecond (4 V/ns) at the
device pin and the input signals are driven between 0V and the appropriate IO supply rail for the signal.
Figure 6-1. Test Load Circuit for AC Timing Measurements
The load capacitance value stated is only for characterization and measurement of AC timing signals. This
load capacitance value does not indicate the maximum load the device is capable of driving.
6.1.1.1 Signal Transition Levels
All input and output timing parameters are referenced to V_ref for both "0" and "1" logic levels. For 3.3 V I/O,
V_ref = 1.65 V. For 1.8 V I/O, V_ref = 0.9 V. For 1.2 V I/O, V_ref = 0.6 V.
V_ref
Figure 6-2. Input and Output Voltage Reference Levels for AC Timing Measurements
All rise and fall transition timing parameters are referenced to V_IL MAX and V_IH MIN for input clocks,
V_OLMAX and V_OH MIN for output clocks.
V_ref = V_IH MIN (or V_OH MIN)
V_ref = V_IL MAX (or V_OL MAX)
Figure 6-3. Rise and Fall Transition Time Voltage Reference Levels
38
Peripheral Information and Electrical Specifications
Copyright © 2010–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: AM1705