AM1705_15 Datasheet, PDF (23/165 Pages) Texas Instruments – AM1705 ARM® Microprocessor

www.ti.com
AM1705
SPRS657E – FEBRUARY 2010 – REVISED JUNE 2014
3.6.12 Timers
Table 3-14. Timers Terminal Functions
SIGNAL NAME
PIN NO
PTP
TYPE⁽¹⁾ PULL⁽²⁾
MUXED
DESCRIPTION
TIMER0
UART0_RXD/I2C0_SDA/TM64P0_IN12/GP5[8]/BOOT[8]
2
UART0_TXD/I2C0_SCL/TM64P0_OUT12/GP5[9]/BOOT[9]
3
I
IPU
Timer0 lower input
UART0, I2C0,
O
IPU ^{GPIO, BOOT}
Timer0 lower
output
TIMER1 (Watchdog )
No external pins. The Timer1 peripheral pins are not pinned out as external pins.
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (i.e., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor
Copyright © 2010–2014, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: AM1705
Device Overview
23