71M6403 Datasheet, PDF (43/75 Pages) Teridian Semiconductor Corporation – Electronic Trip Unit

71M6403
Electronic Trip Unit
SEPTEMBER 2006
Synchronous Serial Interface (SSI): A high-speed serial interface with handshake capability is available to send a contiguous
block of CE data to an external data logger or DSP. The block of data, configurable as to location and size, is sent starting 1
cycle of 32kHz before each CE code pass begins. If the block of data is big enough such that transmission has not completed
when the code pass begins, it will complete during the CE code pass with no timing impact to the CE or the serial data. In this
case, care must be taken that the transmitted data is not modified unexpectedly by the CE. The SSI interface is enabled by the
SSI_EN bit and consists of SCLK, SSDATA, and SFR as outputs and, optionally, SRDY as input. The interface is compatible
with 16bit and 32bit processors. The operation of each pin is as follows:
SCLK is the serial clock. The clock can be 5MHz or 10MHz, as specified by the SSI_10M bit. The SSI_CKGATE bit controls
whether SCLK runs continuously or is gated off when no SSI activity is occurring. If SCLK is gated, it will begin 3 cycles before
SFR rises and will persist 3 cycles after the last data bit is output.
The pins used for the SSI are multiplexed with the LCD segment outputs, as shown in Table 58. Thus, the LCD should be
disabled when the SSI is in use.
SSI Signal
SCLK
SSDATA
SFR
SRDY
LCD Segment
Output Pin
SEG3
SEG4
SEG5
SEG6
Table 58: SSI Pin Assignment
SRDY is an optional handshake input that indicates that the DSP or data-logging device is ready to receive data. SRDY must be
high to enable SFR to rise and initiate the transfer of the next field. It is expected that SRDY changes state on the rising edges of
SCLK. If SRDY is not high when the SSI port is ready to transmit the next field, transmission will be delayed until it is. SRDY is
ignored except at the beginning of a field transmission. If SRDY is not enabled (by SSI_RDYEN), the SSI port will behave as if
SRDY is always one.
SSDATA is the serial output data. SSDATA changes on the rising edge of SCLK and outputs the contents of a block of CE RAM
words starting with address SSI_STRT and ending with SSI_END. The words are output MSB first.
The field size is set with the SSI_FSIZE register: 0 entire data block, 1-8 bit fields, 2-16 bit fields, 3-32 bit fields. The polarity of
the SFR pulse can be inverted with SSI_FPOL. If SRDY does not delay it, the first SFR pulse in a frame will rise on the third
SCLK after MUX_SYNC (fourth SCLK if 10MHz). MUX_SYNC can be used to synchronize the fields arriving at the data logger
or DSP.
Page: 43 of 75
© 2006 TERIDIAN Semiconductor Corporation
REV 1.0