71M6403 Datasheet, PDF (19/75 Pages) Teridian Semiconductor Corporation – Electronic Trip Unit

71M6403
Electronic Trip Unit
SEPTEMBER 2006
Port Registers: The I/O ports are controlled by Special Function Registers P0, P1, and P2. The contents of the SFR can be
observed on corresponding pins on the chip. Writing a ‘1’ to any of the ports (see Table 9) causes the corresponding pin to be at
high level (V3P3), and writing a ‘0’ causes the corresponding pin to be held at low level (GND). The data direction registers
DIR0, DIR1, and DIR2 define individual pins as input or output pins (see the DIO section in On-Chip Resources for details.
Register
P0
DIR0
P1
DIR1
P2
DIR2
SFR R/W Description
Address
0x80 R/W Register for port 0 read and write operations (pins DIO0…DIO7)
0xA2
R/W Data direction register for port 0. Setting a bit to 1 means that the corresponding pin is
an output.
0x90 R/W Register for port 1 read and write operations (pins DIO8…DIO15)
0x91 R/W Data direction register for port 1.
0xA0 R/W Register for port 2 read and write operations (pins DIO16…DIO21)
0xA1 R/W Data direction register for port 2.
Table 9: Port Registers
All four ports on the chip are bi-directional. Each of them consists of a Latch (SFR ‘P0’ to ‘P3’), an output driver, and an input
buffer, therefore the MPU can output or read data through any of these ports if they are not used for alternate purposes.
Special Function Registers Specific to the 71M6403
Table 10 shows the location and description of the 71M6403-specific SFRs.
Register
ERASE
PGADDR
EEDATA
EECTRL
Alternative
Name
FLSH_ERASE
FLSH_PGADR
SFR
R/W Description
Address
0x94
W _{This register is used to initiate either the Flash Mass Erase cycle or the}
Flash Page Erase cycle. Specific patterns are expected for
FLSH_ERASE in order to initiate the appropriate Erase cycle (default =
0x00).
0x55 – Initiate Flash Page Erase cycle. Must be preceded by a write to
FLSH_PGADR @ SFR 0xB7.
0xB7
0x9E
0x9F
0xAA – Initiate Flash Mass Erase cycle. Must be preceded by a write to
FLSH_MEEN @ SFR 0xB2 and the debug port must be
enabled.
Any other pattern written to FLSH_ERASE will have no effect.
R/W _{Flash Page Erase Address register containing the flash memory page}
address (page 0 thru 127) that will be erased during the Page Erase
cycle (default = 0x00).
Must be re-written for each new Page Erase cycle.
R/W I²C EEPROM interface data register
R/W I²C EEPROM interface control register. If the MPU wishes to write a byte
of data to EEPROM, it places the data in EEDATA and then writes the
‘Transmit’ code to EECTRL. The write to EECTRL initiates the transmit
sequence. See the section I2C Interface (EEPROM) for a description of
the command and status bits available for EECTRL.
Page: 19 of 75
© 2006 TERIDIAN Semiconductor Corporation
REV 1.0