LPS35HW Datasheet, PDF (38/48 Pages) STMicroelectronics – Embedded temperature compensation

Register description
8.12 RPDS_L_18h
Pressure offset (LSB data)
Table 28: RPDS_L (18h) register
7
6
5
4
3
2
RPDS7 RPDS6 RPDS5 RPDS4 RPDS3 RPDS2
LPS35HW
1
RPDS1
0
RPDS0
8.13
RPDS[7:0]
This register contains the low part of the pressure offset value.
If, after the soldering of the component, a residual offset is still present, it can be removed
with a one-point calibration.
After the soldering, the measured offset can be stored in the Section 10.13:
"RPDS_H_19h" and Section 10.12: "RPDS_L_18h" registers and automatically subtracted
from the pressure output registers: the output pressure register PRESS_OUT (28h, 29h
and 2Ah) is provided as the difference between the measured pressure and the content of
the register 256*RPDS (18h, 19h)*.
*DIFF_EN = '0', AUTOZERO = '0', AUTORIFP = '0'
RPDS_H_19h
Pressure offset (MSB data)
Table 29: RPDS_H (19h) register
7
6
5
4
3
2
RPDS15 RPDS14 RPDS13 RPDS12 RPDS11 RPDS10
1
RPDS9
0
RPDS8
RPDS[15:8]
This register contains the high part of the pressure offset value.
Refer to Section 10.12: "RPDS_L_18h"
8.14
RES_CONF_1Ah
Low-power mode configuration
Table 30: RES_CONF (1Ah) register
7
6
54
3
2
1
0 ⁽¹⁾
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾
Reserved ⁽²⁾
Notes:
(1)_{These bits must be set to ‘0’ for proper operation of the device.}
(2)_{The content of this bit must not be modified for proper operation of the device}
LC_EN ⁽¹⁾
Low current mode enable. Default 0.
0: Normal mode (low-noise mode); 1: Low-current mode).
0
LC_EN
Notes:
(1)_{The LC_EN bit must be changed only with the device in power down and not during operation. Once LC_EN bit}
is configured, it affects both One-shot mode and Continuous mode.
38/48
DocID029129 Rev 1