LSM330D Datasheet, PDF(33/66 Page) STMicroelectronics

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

LSM330D Datasheet, PDF (33/66 Pages) STMicroelectronics – Low power mode

◁

LSM330D

Digital interfaces

6.1.1

I2C operation

The transaction on the bus is started through a START (ST) signal. A START condition is

defined as a HIGH to LOW transition on the data line while the SCL line is held HIGH. After

this has been transmitted by the master, the bus is considered busy. The next byte of data

transmitted after the start condition contains the address of the slave in the first 7 bits, and

the eighth bit tells whether the master is receiving data from the slave or transmitting data to

the slave. When an address is sent, each device in the system compares the first seven bits

after a start condition with its address. If they match, the device considers itself addressed

by the master.

Data transfer with acknowledge is mandatory. The transmitter must release the SDA line

during the acknowledge pulse. The receiver must then pull the data line LOW so that it

remains stable low during the HIGH period of the acknowledge clock pulse. A receiver which

has been addressed is obliged to generate an acknowledge after each byte of data

received.

The I2C embedded in the LSM330D behaves like a slave device and the following protocol

must be adhered to. After the start condition (ST), a slave address is sent. Once a slave

acknowledge (SAK) has been returned, an 8-bit sub-address (SUB) is transmitted: the 7

LSb represent the actual register address while the MSb enables address auto increment. If

the MSb of the SUB field is â1â, the SUB (register address) will be automatically increased to

allow multiple data read/write.

Table 12.

Master

Slave

Transfer when master is writing one byte to slave

SAD + W

SUB

DATA

SAK

Table 13. Transfer when master is writing multiple bytes to slave

Master ST SAD + W

SUB

DATA

Slave

SAK

Table 14. Transfer when master is receiving (reading) one byte of data from slave

Master ST SAD + W

SUB

SR SAD + R

NMAK SP

Slave

SAK

SAK DATA

Table 15. Transfer when master is receiving (reading) multiple bytes of data from slave

Master ST SAD+W

SUB

SR SAD+R

MAK

NMAK SP

Slave

SAK

SAK DATA

DATA

Data is transmitted in byte format (DATA). Each data transfer contains 8 bits. The number of

bytes sent per transfer is unlimited. Data is transferred with the most significant bit (MSb)

first. If a receiver cannot receive another complete byte of data until it has performed some

other function, it can hold the clock line, SCL, LOW to force the transmitter into a wait state.

Doc ID 022562 Rev 2

33/66

▷