VS6663CC Datasheet, PDF (25/63 Pages) STMicroelectronics – 1.3 megapixel camera module

VS6663CC
Camera control interface (CCI)
4.2.5 Setup registers [0x0100 to 0x01FF]
Table 14. Setup registers [0x0100 to 0x01FF]
Index Byte
Register name
Data type Default Type
Comment
0x0100
mode_select
Mode select
0x00 - Software standby
8UI
00 RW _{0x01 - Streaming}
Refer to Section 3.2: Device
operating modes on page 13
0x0101
image_orientation
Image orientation, that is, horizontal
mirror and vertical flip.
8B
00
RW
Bit 0: 0 - no mirror, 1 - horizontal
mirror enable
Bit 1: 0 - no flip, 1 - vertical flip
enable
0x0103
software_reset
Software reset. Setting this register
to 1 resets the sensor to its power
up defaults. The value of this bit is
also reset
8UI
00
RW _{0x00 - normal}
0x01 - soft reset
Refer to Section 3.2: Device
operating modes on page 13
0x0104
grouped_parameter_hold
The grouped parameter hold
register disables the consumption of
integration, gain and video timing
parameters
0x00 - consume parameters as
8UI
00
RW _normal
0x01 - hold parameters
Refer to Section 6.3.3: Integration
and gain parameter retiming on
page 45
0x0105
mask_corrupted_frames
Setting this register to 1 prevents the
sensor outputing frames that have
been corrupted by video timing
8UI
00
RW _{parameter changes.}
0x00 - normal
0x01 - mask corrupted frames
0x0110
csi_channel_identifier
The DMA (CCP2) or Virtual (CSI2)
channel identifier
8UI
00
RW _{Valid range: 0-7 for CCP2}
Valid range: 0-3 for CSI-2
0x0111
csi_signalling_mode
0x00 - CCP2 Data/clock signalling:
0x01 - CCP2 Data/strobe signalling:
8UI
02 RW 0x02 - CSI-2:
This register should not be changed
while the device is streaming data.
Doc ID028526 Rev 1
25/63
46