ISL6398 Datasheet, PDF (57/57 Pages) Intersil Corporation – Programmable soft-start rate and DVID rate

ISL6398
Package Outline Drawing
L40.5x5
40 LEAD THIN QUAD FLAT NO-LEAD PLASTIC PACKAGE
Rev 2, 7/14
6
PIN 1
INDEX AREA
5.00 ± 0.05
A
B
4 x 3.60
36 x 0.40
6
PIN #1 INDEX AREA
(4X)
0.15
PACKAGE OUTLINE
TOP VIEW
40x0.4 ± 0.1
BOTTOM VIEW
b
4
0.20
0.10 M
C
AB
0.40
0.750 ± 0.10
(36 x 0.40)
0.050
SIDE VIEW
SEE DETAIL “X”
// 0.10 C
BASE PLANE ^C
SEATING PLANE
0.08 C
(40 x 0.20)
(40 x 0.60)
TYPICAL RECOMMENDED LAND PATTERN
0.2 REF
C
5
0.00 MIN
0.05 MAX
DETAIL "X"
NOTES:
1. Dimensions are in millimeters.
Dimensions in ( ) for Reference Only.
2. Dimensioning and tolerancing conform to AMSE Y14.5m-1994.
3. Unless otherwise specified, tolerance: Decimal ± 0.05
4. Dimension b applies to the metallized terminal and is measured
between 0.15mm and 0.27mm from the terminal tip.
5. Tiebar shown (if present) is a non-functional feature.
6. The configuration of the pin #1 identifier is optional, but must be
located within the zone indicated. The pin #1 identifier may be
either a mold or mark feature.
7. JEDEC reference drawing: MO-220WHHE-1
Submit Document Feedback ₅₇
FN8575.1
August 13, 2015