H8S-2258 Datasheet, PDF (283/1071 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family H8S-2200 Series

Section 7 Bus Controller
7.9 Bus Release
This LSI can release the external bus in response to a bus request from an external device. In the
external bus released state, the internal bus master continues to operate as long as there is no
external access.
In external extended mode, the bus can be released to an external device by setting the BRLE bit
in BCRL to 1. Driving the BREQ pin low issues an external bus request to this LSI. When the
BREQ pin is sampled, at the prescribed timing the BACK pin is driven low, and the address bus,
data bus, and bus control signals are placed in the high-impedance state, establishing the external
bus-released state.
In the external bus released state, an internal bus master can perform accesses using the internal
bus. When an internal bus master wants to make an external access, it temporarily defers
activation of the bus cycle, and waits for the bus request from the external bus master to be
dropped.
When the BREQ pin is driven high, the BACK pin is driven high at the prescribed timing and the
external bus released state is terminated.
In the event of simultaneous external bus release request and external access request generation,
the order of priority is as follows:
(High) External bus release > Internal bus master external access (Low)
Table 7.5 shows pin states in the external bus released state.
Table 7.5 Pin States in Bus Released State
Pins
A23 to A0
D15 to D0
CSn
AS
RD
HWR
LWR
Pin State
High impedance
High impedance
High impedance
High impedance
High impedance
High impedance
High impedance
Rev. 5.00 Aug 08, 2006 page 197 of 982
REJ09B0054-0500