M16C6NL Datasheet, PDF (257/388 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NL, M16C/6NN)
19.15.2 Transmission
Figure 19.22 shows the timing of the transmit sequence.
19. CAN Module
SOF
CTX
ACK
EOF
IFS SOF
TrmReq bit
(1)
TrmActive bit
(1)
(2)
(4)
(3)
SentData bit
(3)
CAN0 Successful
(3)
Transmission Interrupt
TrmState bit
(1)
(2)
TrmSucc bit
MBOX bit
Transmission slot No.
j = 0 to 15
Figure 19.22 Timing of Transmit Sequence
(1) If the TrmReq bit in the C0MCTLj register (j = 0 to 15) is set to “1” (Transmission slot) in the bus idle
state, the TrmActive bit in the C0MCTLj register and the TrmState bit in the C0STR register are set to
“1” (Transmitting/Transmitter), and CAN module starts the transmission.
(2) If the arbitration is lost after the CAN module starts the transmission, the TrmActive and TrmState bits
are set to “0”.
(3) If the transmission has been successful without lost in arbitration, the SentData bit in the C0MCTLj
register is set to “1” (Transmission is successfully completed) and TrmActive bit is set to “0” (Waiting
for bus idle or completion of arbitration). And when the interrupt enable bits in the C0ICR register = 1
(Interrupt enabled), CAN0 successful transmission interrupt request is generated and the MBOX (the
slot number which transmitted the message) and TrmSucc bit in the C0STR register are changed.
(4) When starting the next transmission, set the SentData and TrmReq bits to “0”. And set the TrmReq bit
to “1” after checking that the SentData and TrmReq bits are set to “0”.
Rev.2.00 Nov 28, 2005 page 241 of 364
REJ09B0126-0200