M16C6NL Datasheet, PDF (109/388 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NL, M16C/6NN)
10. Interrupt
______
10.7 NMI Interrupt
_______
_______
______
An NMI interrupt request is generated when input on the NMI pin changes state from high to low. The NMI
interrupt is a non-maskable interrupt.
_______
The input level of this NMI interrupt input pin can be read by accessing the P8_5 bit in the P8 register.
This pin cannot be used as an input port.
10.8 Key Input Interrupt
Of P10_4 to P10_7, a key input interrupt request is generated when input on any of the P10_4 to P10_7
pins which has had the PD10_4 to PD10_7 bits in the PD10 register set to “0” (input) goes low. Key input
interrupts can be used as a key-on wake up function, the function which gets the microcomputer out of wait
or stop mode. However, if you intend to use the key input interrupt, do not use P10_4 to P10_7 as analog
input ports. Figure 10.14 shows the block diagram of the key input interrupt. Note, however, that while input
on any pin which has had the PD10_4 to PD10_7 bits set to “0” (input mode) is pulled low, inputs on all other
pins of the port are not detected as interrupts.
Pull-up
transistor
KI3
Pull-up
transistor
KI2
Pull-up
transistor
KI1
Pull-up
transistor
KI0
PU25 bit in PUR2 register
PD10_7 bit in PD10 register
PD10_7 bit in PD10 register
PD10_6 bit in
PD10 register
PD10_5 bit in
PD10 register
PD10_4 bit in
PD10 register
Figure 10.14 Key Input Interrupt Block Diagram
KUPIC register
Interrupt control circuit
Key input interrupt
request
10.9 CAN0 Wake-up Interrupt
CAN0 wake-up interrupt request is generated when a falling edge is input to CRX0. The CAN0 wake-up
interrupt is enabled only when the PortEn bit = 1 (CTX/CRX function) and Sleep bit = 1 (Sleep mode
enabled) in the C0CTLR register. Figure 10.15 shows the block diagram of the CAN0 wake-up interrupt.
Please note that the wake-up message will be lost.
Sleep bit in C0CTLR register
PortEn bit in C0CTLR register
CRX0
C01WKIC register
Interrupt control
circuit
Figure 10.15 CAN0 Wake-up Interrupt Block Diagram
Rev.2.00 Nov 28, 2005 page 93 of 364
REJ09B0126-0200
CAN0 wake-up
interrupt request