CP5.241 Datasheet, PDF (21/26 Pages) PULS GmbH – 24V, 5A, 120W, SINGLE PHASE INPUT

PRELIMINARY
CP-Series
CP5.241, CP5.241-C1,
CP5.241-S1, CP5.241-S2
24V, 5A, 120W, SINGLE PHASE INPUT
23.4. UF20.241 BUFFER MODULE
This buffer unit is a supplementary device for DC 24V power supplies. It delivers power to
bridge typical mains failures or extends the hold-up
time after turn-off of the AC power. In times when
the power supply provides sufficient voltages, the
AC
Power Buffer
Supply Unit(s)
Load
buffer unit stores energy in integrated electrolytic
capacitors. In case of mains voltage fault, this energy
DC
+
-
is released again in a regulated process. One buffer
module can deliver 20A additional current.
The buffer unit does not require any control wiring. It can be added in parallel to the load
circuit at any given point. Buffer units can be added in parallel to increase the output
ampacity or the hold-up time.
23.5. ZM6.WALL – WALL/PANEL MOUNT BRACKET
This bracket is used to mount the devices on a wall/panel without utilizing a DIN-Rail. It is suitable for CP5.241,
CP5.241-C1, CP5.241-S1 and CP5.241-S2.
The bracket can be mounted without detaching the DIN-rail brackets.
Fig. 23-1 Isometric view
(Picture shows the CP5.241)
Fig. 23-2 Isometric view-
(Picture shows the CP5.241)
Fig. 23-3 Isometric view
(Picture shows the CP5.241)
Fig. 23-4 Wall/panel mounting, front
view (Picture shows the CP5.241)
Fig. 23-5 Hole pattern for wall
mounting
Fig. 23-6 Wall/panel mounting,
side view (Picture shows the CP5.241)
Aug. 2017 / Rev. 0.1 DS-CP5.241-EN
All parameters are typical values specified at 24V, 5A output, 230Vac input, 25°C ambient and
after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
21/26