CP5.241 Datasheet, PDF (12/26 Pages) PULS GmbH – 24V, 5A, 120W, SINGLE PHASE INPUT

PRELIMINARY
CP-Series
CP5.241, CP5.241-C1,
CP5.241-S1, CP5.241-S2
24V, 5A, 120W, SINGLE PHASE INPUT
CP5.241-S2
Type
Solid wire
Stranded wire
Stranded wire with ferrules
American Wire Gauge
Max. wire diameter (including ferrules)
Wire stripping length
Screwdriver
Input
Push-in termination
Max. 2.5mm²
Max. 2.5mm²
Max. 1.5mm²
AWG 24-12
2.3mm
10mm / 0.4inch
3.0mm slotted to open
the spring
Output
Push-in termination
Max. 10mm²
Max. 6mm²
Max. 4mm²
AWG 24-8
3.3mm
15mm / 0.6inch
3.5mm slotted to open
the spring
DC-OK-Signal
Push-in termination
Max. 1.5mm²
Max. 1.5mm²
Max. 1.5mm²
AWG 24-16
1.6mm
7mm / 0.28inch
3mm slotted to open
the spring
Instructions for wiring:
a) Use appropriate copper cables that are designed for minimum operating temperatures of:
60°C for ambient up to 45°C and
75°C for ambient up to 60°C and
90°C for ambient up to 70°C minimum.
b) Follow national installation codes and installation regulations!
c) Ensure that all strands of a stranded wire enter the terminal connection!
d) Unused terminal compartments should be securely tightened.
e) Ferrules are allowed.
Daisy chaining:
Daisy chaining (jumping from one power supply output to the next) is allowed as long as the average output current
through one terminal pin does not exceed 25A or 15A for the CP5.241-S2. If the current is higher, use a separate
distribution terminal block as shown in Fig. 13-2.
Fig. 13-1 Daisy chaining of outputs
Power
Supply
++- -
Output
Power
Supply
++- -
Output
Load
+-
Maximal 15A continuous for CP5.241-S2
Maximal 25A continuous for all other units
Fig. 13-2 Using distribution terminals
Power
Supply
+ +- -
Output
Power
Supply
+ +- -
Output
Distribution
Terminals
Load
+-
Aug. 2017 / Rev. 0.1 DS-CP5.241-EN
All parameters are typical values specified at 24V, 5A output, 230Vac input, 25°C ambient and
after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
12/26