MC68HC912B32 Datasheet, PDF (48/128 Pages) Motorola, Inc – 16-Bit Microcontroller

$_D00
$_E00
$_F00
$_F80
$_FC0
BPROT4
(256 BYTES)
BPROT3
(256 BYTES)
BPROT2
(128 BYTES)
BPROT1
BPROT0
SINGLE CHIP VECTORS
RESERVED (64 BYTES)
VECTORS (64 BYTES)
$FF80
$FFBF
$FFC0
$FFFF
HC912B32 EEPROM BLOCK PROT
Figure 9 EEPROM Block Protect Mapping
8.2 EEPROM Control Registers
EEMCR — EEPROM Module Configuration
Bit 7
6
5
4
1
1
1
1
RESET:
1
1
1
1
$00F0
3
2
1
Bit 0
1
EESWAI PROTLCK EERC
1
1
0
0
EESWAI — EEPROM Stops in Wait Mode
0 = Module is not affected during wait mode
1 = Module ceases to be clocked during wait mode
This bit should be cleared if the wait mode vectors are mapped in the EEPROM array.
PROTLCK — Block Protect Write Lock
0 = Block protect bits and bulk erase protection bit can be written
1 = Block protect bits are locked
Read anytime. Write once in normal modes (SMODN = 1), set and clear any time in special modes
(SMODN = 0).
EERC — EEPROM Charge Pump Clock
0 = System clock is used as clock source for the internal charge pump. Internal RC oscillator is
stopped.
1 = Internal RC oscillator drives the charge pump. The RC oscillator is required when the system
bus clock is lower than f_PROG.
Read and write anytime.
EEPROT — EEPROM Block Protect
$00F1
Bit 7
6
5
4
3
2
1
Bit 0
1
1
1
BPROT4 BPROT3 BPROT2 BPROT1 BPROT0
RESET:
1
1
1
1
1
1
1
1
Prevents accidental writes to EEPROM. Read anytime. Write anytime if EEPGM = 0 and PROTLCK = 0.
MOTOROLA
48
MC68HC912B32
MC68HC912B32TS/D