English
Language : 

PIC32MX3XX_1 Datasheet, PDF (171/208 Pages) Microchip Technology – High-Performance, General Purpose and USB 32-bit Flash Microcontrollers
PIC32MX3XX/4XX
FIGURE 29-10:
SCKx
(CKP = 0)
SCKx
(CKP = 1)
SPIx MODULE MASTER MODE (CKE = 0) TIMING CHARACTERISTICS
SP11
SP10
SP21
SP20
SP35
SP20
SP21
SDOx
MSb
SDIx
SP31
MSb In
SP40 SP41
Note: Refer to Figure 29-1 for load conditions.
Bit 14 - - - - - -1
LSb
Bit 14 - - - -1
SP30
LSb In
TABLE 29-28: SPIx MASTER MODE (CKE = 0) TIMING REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 2.3V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
Param.
No.
Symbol
Characteristics(1)
Min. Typical(2) Max. Units
Conditions
SP10 TSCL
SCKx Output Low Time
TSCK/2
—
— nsec
—
(Note 3)
SP11 TSCH
SCKx Output High Time
TSCK/2
—
— nsec
—
(Note 3)
SP20 TSCF
SCKx Output Fall Time
(Note 4)
—
—
— nsec See parameter DO32.
SP21 TSCR
SCKx Output Rise Time
(Note 4)
—
—
— nsec See parameter DO31.
SP30 TDOF
SDOx Data Output Fall Time
—
(Note 4)
—
— nsec See parameter DO32.
SP31 TDOR
SDOx Data Output Rise Time
—
(Note 4)
—
— nsec See parameter DO31.
SP35 TSCH2DOV, SDOx Data Output Valid after
—
TSCL2DOV SCKx Edge
—
—
15 nsec
—
20 nsec
VDD > 2.7V
VDD < 2.7V
SP40 TDIV2SCH, Setup Time of SDIx Data Input 10
—
— nsec
—
TDIV2SCL to SCKx Edge
SP41 TSCH2DIL, Hold Time of SDIx Data Input
10
—
— nsec
—
TSCL2DIL to SCKx Edge
Note 1: These parameters are characterized, but not tested in manufacturing.
2: Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
3: The minimum clock period for SCKx is 40 nsec. Therefore, the clock generated in Master mode must not
violate this specification.
4: Assumes 50 pF load on all SPIx pins.
© 2010 Microchip Technology Inc.
DS61143G-page 171