|
409-10093 Datasheet, PDF (31/37 Pages) Tyco Electronics – Safeguards are designed into this application equipment to protect operators and maintenance personnel from most hazards during equipment operation | |||
|
◁ |
Pin-Barrel Insertion Module 2031100-1
409-10093
B. Rotary Power Unit
The Rotary Power Unit uses an air cylinder to open the inserter clamp; therefore, the opening of the
inserter clamp opening cannot be adjusted.
5.14. Terminal Drag Pressure Adjustment (Refer to Figure 21)
The terminal drag pressure is preâset and should not require adjustment; however, if necessary, adjust the
pressure as follows:
1. Make sure that the electrical power and air supply is disconnected from the base machine.
2. Loosen the jam nut located on the adjustment set screw of the drag housing.
3. Rotate the adjustment set screw clockwise (moves âinâ) to increase the drag pressure and
counterâclockwise (moves âoutâ) to decrease the drag pressure. The drag pressure should be set to the
minimum amount required for consistent operation.
4. Reâtighten the jam nut.
Terminal Drag Pressure Adjustment
Rev A
Drag Pressure
Adjustment Nuts
Rotate Clockwise to Increase Terminal Drag Pressure
Rotate Counter-Clockwise to Decrease Terminal Drag Pressure
Figure 21
Tyco Electronics Corporation
31 of 37
|
▷ |