409-10093 Datasheet, PDF (10/37 Pages) Tyco Electronics – Safeguards are designed into this application equipment to protect operators and maintenance personnel from most hazards during equipment operation

Pin-Barrel Insertion Module 2031100-1
409-10093
3. INSTALLATION
Verify that the correct lower tooling tip (single–acting or double–acting; terminal specific) and power unit
(straight or rotary; application specific) are being used for the tool set and type of terminal being applied (refer
to Section 1 for description). For additional information, refer to the assembly drawings included with the tool
set documentation.
DANGER
To avoid personal injury, ALWAYS DISCONNECT the electrical power and air supply from the base machine before
installing or removing components.
3.1. Installing Power Unit onto Machine
When installing the Rotary Power Unit onto the machine, the machine must be equipped with Rotary
Integration Kit 2031280–1. When installing the Straight Power Unit onto a machine equipped with the rotary
integration kit, the air lines and electrical connector (which are part of the rotary integration kit) will not be used
and must be disconnected and unplugged
CAUTION
!
To avoid any possible damage to the equipment, remove or secure any unused air and electrical connectors to prevent
them from interfering with any moving components.
Proceed as follows:
1. Disconnect the electrical power and air supply from the base machine.
DANGER
To avoid personal injury, ALWAYS DISCONNECT the electrical power and air supply from the base machine before
installing the power unit onto the machine.
2. Position the mounting holes of the power unit over the four mounting screws of the machine gantry.
Refer to Figure 4.
3. Move the power unit back and downward until it is properly seated on the gantry. Ensure that the
dowel pin is properly located in the alignment slot of the gantry.
4. Tighten the four mounting screws.
5. Connect the CPC electrical connector(s) and air lines from the machine to the power unit (numbers
are marked on the air lines). For proper connections, refer to Figure 5.
10 of 37
Tyco Electronics Corporation
Rev A